This site is 100% ad supported. Please add an exception to adblock for this site.

DENTAL TECHNICHAN VOLUME 1 NAVEDTRA 14274

Terms

undefined, object
copy deck
How many 10-second rinses with a mouthwash will temporarily reduce a patient's microbial count?
3
Waterless handwashing agents that contain 70 percent isopropyl alcohol virtually disinfect the skin in how many seconds?
20S
What protective surface material helps bacteria evade the defense mechanisms of the body?
COATING
When must you clean and disinfect the previously covered surfaces between patients?
When surface is visibly soiled
Approximately how many deaths occur annually from HBV infection?
200
The purpose of handwashing is to remove micro-organisms from what area of the skin?
Folds and grooves
What technique is used to clean unprotected areas between patients?
Spray-wipe-spray
How many maximum minutes are most viruses susceptible to while immersed in boiling water?
20MIN
Cannot be sterilized because of their design or inability to withstand heat.
SEMI-CRITICAL ITEMS.
What type of gloves offer the highest quality and best fit at a greatly reduced cost?
PROCEDURAL
How many medium-sized bacteria may be contained in a single drop of water?
2 billion
Where should wrapping material be placed on open instrument trays, packs, or cassettes to protect work surfaces against contamination?
UNDERNEATH
Instruments and materials that penetrate the skin, mucous membranes, or bone.
CRITICAL ITEMS
Which of the following supplies and equipment can reduce the volume of aerosols and decrease the level of micro-organisms during dental procedures?
HVE's and rubber dams
How long should you flush each of the unit water lines and hoses for at the beginning of each work day?
1 MINUTE
Which of the following is the most common mold infection in humans?
RING WORM
When securing the DTR at the end of the day, how many quarts of water should be flushed through the HVE?
1
Washing increases the porosity of gloves up to what maximum percent
60
When using a detergent with sodium hypochlorite, what dilution ratio is recommended?
1:100

Deck Info

19

permalink